Butler claim of Overunity using Bedini principles
KeelyNet - 11/28/04
This was sent to the KeelyNet Interact discussion list on 11/26/04, with photos which the list cannot accept. So I cleaned them up as best I could and am posting in this file so everyone can see what Emmett referenced.
Good Afternoon All,
TO START:I believe O.U. does indeed exist.
There are some different ways to do this, some simple, and a little energy - some a bit, how shall I say more complex, but unbelievable amounts of energy, I know, been there and have done it.
HERE IS A SIMPLE WAY TO ACHIEVE THIS!!!!!
BUT FIRST; As I always give credit where credit is due, first and foremost to John Bedini for his motor/energizers, Tom Bearden for the math and help in seeing what isn't always obvious, on his website, to my friend, Stan Mayer, for thoughts, encouragement and how to do things with what few electronic parts are available in my area, i.e. Radio Shack, and to all the greats before me, Maxwell, Faraday, Stubblefield and especially Tesla.
NOW ON TO BUSINESS: I will provide a brief description and as you all can see there are photos, and if any are in my area or want to come to my shop, I will be glad to let you see, tinker and photograph to your hearts desire, on this project anyway.
1). We will start with Johns' school girl energizer (simplified) first. There are many of you out there that I know of that have achieved minor o.u. in the .01 - .1 - .2 volt range for periods of time, there are those of you who have achieved a 1-1 unity,
i.e., trading the same voltage back and forth between batteries over time and the voltage does not go up or down although in practical situations (not this) it would normally go down over time due to resistance in the wires, resistance in the bearings, air resistance of the rotor rotating, and general quality of workmanship,
there are those of you who are close to 1-1 unity but are only losing .1 - .3 volts over a 24 hr. period, that is good too, but not good enough but not to worry.
I have included in the pictures, photo1, of my SG energizer, "the black widow" so you can see all the wires and circuitry etc. nothing hidden, nothing magical.
Photo #2). rear view with a small coil with a screw through the center attached to a copper/PVC pipe stand, the leads are attached to a home-made 4-diode, simple full wave bridge rectifier, (4) IN4003 diodes, or a standalone manufactured one will work also with a cap. connected across to smooth out the spikes.
I originally used a reed switch but they have a tendency to burn shut and last only so long, so I asked my buddy, Stan Mayer, what I could substitute, thanks Stan.
Yes I know the pictures are dark, using an old Polaroid Instamatic, flash burned out, but I wanted pictures, NOW, you will notice that the leads from the fullwave bridge rectifier are connected to a DVM and it reads 6.13 volts.
Now this little coil is made from a screw about an inch long and 3/16" in dia. wrapped with radio shack 28g wire about 200' worth. This is far in excess of those who are losing .1 - .13 volts every 24 hrs or so O.U. IN MY BOOK...BUT IT GETS BETTER.
Photo # 3). is just a side view.
Photo #4). now some of you have found that you don't need your wheel to rotate at all, that by just stacking your magnets on top and a few adjustments it becomes a resonate circuit and some of you are finding that it is still charging your batteries, both input and output at the same time, this is more than possible,
Stan explained how the electronics do indeed do this through a little window in time (pun intended).
Picture #4 is mine doing just that BUT IT GETS EVEN BETTER!!!!!!!!!!!!!!!
NOT ONLY DO YOU NOT NEED A ROTOR ROTATING, YOU DON'T NEED MAGNETS TO MAKE IT RESONATE, JUST ANOTHER COIL,
photo #5, show my coil sitting on top, it is smaller than the main coil, so needed to get it closer, although side by side it will still provide a voltage, just not as big, now!!
1, if you make your coils larger, the same size and attach the circuit I described above, you not only achieve O.U. in charging the two batteries, but you can run extra voltage even above, the DVM reads 2.579 volts in case you can't see it.
SO NOW YOU NOT ONLY HAVE O.U., IN ONE SYSTEM BUT A SECOND SYSTEM AND THERE IS NO MOVEMENT, POSSIBLY A SIMPLIFIED MEG WITH SIMPLIFIED STUFF, BUT I CAN'T NOT SAY FOR SURE, EITHER WAY IT IS A NON-MOVING GENERATOR THAT YOU ALL CAN BUILD EASILY IN A COUPLE OF HOURS!!!!!!!!!!!!!!!
I ask only one or two things, PLEASE, tell and send this to all your family, friends, other energy sites, Rense.com , papers, radio, tv, or whatever as the momentum needs to raise sharply, like the spike on a scope of radiant energy as some have seen, or this will die a very quick death and my other peripheral devices along these lines are not worth putting out and I shall go into quiet retirement.
ALSO.. any who want to come to my office and shop to see, tinker, experiment, and photograph etc. are more than welcome, I have NOTHING TO HIDE. my address is
Westwood/'Westside Apts. Office,
1015 Oakcrest St.
Iowa City, Iowa
8-6 or so Mon.,-Fri.
and about 9:30 1:00 or so on Sat.
Emmett L. Butler
Photo montage Emmett sent in originally